CY7C63723-SXC
enCoRe™ USB Combination Low-Speed USB and PS/2 Peripheral Controller
Features
enCoRe™ USB - enhanced Component Reduction
Internal oscillator eliminates the need for an external
crystal or resonator
Interface can auto-configure to operate as PS/2 or
USB without the need for external components to
switch between modes (no General Purpose I/O
[GPIO] pins needed to manage dual mode capability)
Internal 3.3V regulator for USB pull-up resistor
Configurable GPIO for real-world interface without
external components
Flexible, cost-effective solution for applications that
combine PS/2 and low-speed USB, such as mice, gamepads, joysticks, and many others.
USB Specification Compliance
Conforms to USB Specification, Version 2.0
Conforms to USB HID Specification, Version 1.1
Supports one low-speed USB device address and
three data endpoints
Integrated USB transceiver
3.3V regulated output for USB pull-up resistor
8-bit RISC microcontroller
Harvard architecture
6-MHz external ceramic resonator or internal clock
mode
12-MHz internal CPU clock
Internal memory
256 bytes of RAM
8 Kbytes of EPROM
Interface can auto-configure to operate as PS/2 or
USB
No external components for switching between PS/2
and USB modes
No GPIO pins needed to manage dual mode
capability
I/O ports
Up to 16 versatile GPIO pins, individually
configurable
High current drive on any GPIO pin: 50 mA/pin
current sink
Each GPIO pin supports high-impedance inputs,
internal pull-ups, open drain outputs or traditional
CMOS outputs
Maskable interrupts on all I/O pins
SPI serial communication block
Master or slave operation
2 Mbit/s transfers
Four 8-bit Input Capture registers
Two registers each for two input pins
Capture timer setting with five prescaler settings
Separate registers for rising and falling edge capture
Simplifies interface to RF inputs for wireless
applications
Internal low-power wake-up timer during suspend
mode
Periodic wake-up with no external components
Optional 6-MHz internal oscillator mode
Allows fast start-up from suspend mode
Watchdog Reset (WDR)
Low-voltage Reset at 3.75V
Internal brown-out reset for suspend mode
Improved output drivers to reduce EMI
Operating voltage from 4.0V to 5.5VDC
Operating temperature from 0°C to 70°C
CY7C63723 available in 18-pin SOIC, 18-pin PDIP
CY7C63743 available in 24-pin SOIC, 24-pin PDIP, 24-pin
QSOP
CY7C63722 available in DIE form
Industry standard programmer support
Because of wholesale price is different from sample price, our website can not state.Please send your required part number via email to Sales@hkmjd.com or add our skype id mjdccm898 for online talking.As well as welcome you call us : 0755-83957301 We will send offer for you; Sometimes manufacturer's price is unstable, so we don't adjust price in time. if you feel price is a little high for you, just feel free to contact us for consultation. Thank you for your support !
批發與零售價位不同,無法一一明示,詳情請通過郵件或客服咨詢(國內銷售部電話:0755-83957301,企業QQ2850151585), 由于電子元器件價格不穩定,時常有稍許變動,本公司未能及時調整,如您覺得售價不適,請與我們說明并適當議價,謝謝支持。